Not something I have any experience with but please allow me opine from my armchair:
the only problems I forsee with that approach are:
– any bends you might have to navigate
– supporting/stabilizing the new pipe
– sealing the top to prevent a down draft forming between them and pulling exhaust into your home
There are no bends, or I wouldn’t even consider it, and figuring out the support/stabilizing of the new pipe would likely tie into sealing it to prevent the downdraft.
Yes, but I need to make sure it doesn’t increase the airflow by a very large margin, or it affects the stove in a very negative way (either burning dangerously hot, or causing smoke to go the wrong way, etc).
Mostly I need to inspect what’s currently in place and see what fits where to figure out what I am doing.
Replacing our incredibly sketchy wood stove with a gravity fed pellet stove.
Still mulling over how to replace the pipe on the roof, since the opening was built for a 7" pipe and the pellet stove requires a 3-4" pipe at most.
Heavily considering running the new pipe through the current one and paying someone to do it right next year.
Not something I have any experience with but please allow me opine from my armchair:
the only problems I forsee with that approach are:
– any bends you might have to navigate – supporting/stabilizing the new pipe – sealing the top to prevent a down draft forming between them and pulling exhaust into your home
There are no bends, or I wouldn’t even consider it, and figuring out the support/stabilizing of the new pipe would likely tie into sealing it to prevent the downdraft.
Those are good points though.
I’m not familiar with pellet stoves, but would a converter work so you can reuse the old exhaust pipe in place?
https://www.homedepot.com/p/Master-Flow-7-in-to-4-in-Round-Reducer-R7X4/202191795
Yes, but I need to make sure it doesn’t increase the airflow by a very large margin, or it affects the stove in a very negative way (either burning dangerously hot, or causing smoke to go the wrong way, etc).
Mostly I need to inspect what’s currently in place and see what fits where to figure out what I am doing.