• ThatWeirdGuy1001@lemmy.world
      link
      fedilink
      arrow-up
      0
      ·
      edit-2
      6 months ago

      My last car was a 2012 ford fiesta. The lug nuts are 19mm. The caliper bolts were 10mm and the slide bolts were 3/8.

      The car before that was a 2001 cavalier. Not only did it have metric and standard bolts but the slide bolts were fuckin Allen heads.

      Like literally why?

      • pancakes@sh.itjust.works
        link
        fedilink
        English
        arrow-up
        0
        ·
        6 months ago

        Probably because they were made by American car manufacturers and couldn’t make a logical or consistent design decision if their lives depended on it.

        • ThatWeirdGuy1001@lemmy.world
          link
          fedilink
          arrow-up
          0
          ·
          6 months ago

          Like I’m not even an engineer and I’m just screaming about the dumbest decisions made by people who make more in a week than I make in a year 😭

          • Maalus@lemmy.world
            link
            fedilink
            arrow-up
            0
            ·
            6 months ago

            Yeah, but the difference is that they made it so you need an extra socket or an alan wrench. I think you’d have made dumb decisions that were a little bit more deadly.

      • BilboBargains@lemmy.world
        link
        fedilink
        arrow-up
        0
        ·
        6 months ago

        It’s usually cost. They have tooling for components that have probably been around decades. The cost of retooling just to change the fastener sizes may not be economically viable. Eventually these legacy components will be phased out and it will be 100% metric.