I use the store.php method. Works fine for my use case.

I don’t actually sync it, I have it on my LAN web server along with my home page etc…

Thanks!

It’s only a few hundred pages and still works well enough I haven’t felt the need to move to anything new.

I’ve been using Tiddly Wiki for years now.

It’s just a single file, so no need for a dedicated container!

It took about 6 hours, but could have done with going a bit slower.

I’ve been eying up the independent hot end versions. The results look fantastic!

Can’t believe I didn’t think of that after all the frogs it’s printed!

This was printed on a printer with dual extruders. It’s a few years old now, there are some much better ones out there now if you look for multi material or dual extruder printers.

Not too much really, just the full height skirt and purged on the infill.

My small setup.

Thanks!

Here’s the mk1 STLs.