Depends where you live. I live in a desert so humidity isn’t an issue, but dust is. I keep most of my filament in bags just to protect from dust. The only one I actually vacuum seal is tpu. Pla, pla+, and petg all do fine without. If I store it for more than a year though, I run it through the dryer first. Or at least have the dryer running while I print from it.
1302.2 hours on DayZ. Havent played since april though. Its a game ill play 30 hours a week until a server reset and then I wont touch it for months.
Destiny 2 and elden ring have been my latest ones though with 469 hours on ER and 365 on destiny 2.
It is against the steam subscriber agreement to use a VPN. Particularly if you’re using it to get around a region restricted game. Will they check and catch you? Probably not, but they can. It’s definately not recommended though.
Make sure you calibrate your e-steps after swapping hotends. I did the same thing on my ender 3 putting on a volcano hotend, and started getting overextrusion. After adjusting the e-steps it was back to normal.
Check for a partial clog. 80% of the time i get that consistency with petg, its because the nozzle is partially clogged. The other 20% is the ptfe tubing is shot. Usually it partially melts and causes underextrusion.
Wet filament could be an issue too, but this is pretty extreme for wet filament.
Halloween Ends (2022)
I watched it in theaters when it came out and really liked it. Interesting slasher movie with good scenes and a good plot. Yes, I wish they would have let Cory keep the spirit of Michael alive, but it is probably better to let the character die in peace.
But then i saw all the Michael Myers fans hating on it afterwards and never understood why. 40% on rotten tomatoes.
Just change your view to desktop viewer.