- Transfem: Born in a male body, identifies as female
- Femboy: Born in a male body, identifies as male, likes to behave and/or dress in what is traditionally seen as feminine
It gets even worse when a number of anime aren’t even licensed for your country so you can only stream them via VPN. Looking at you Crunchyroll
Yeah, I’m still stuck on Google Keep, since it’s the only one that’s integrated with the (even worse) Google home
And for the love of god don’t go for latest, just stick to the release tags
Might want to rethink the name Redox OS already exists and is a pretty active project to create a modern OS in Rust
Be a bit quieter please, I just woke up
Thank you for the tip, just registered for one!
I would absolutely love to go there, but I sadly can’t afford a ticket right now
Yeah, I expected oozing and stringing with PETG, but not with PLA. For now I’ve switched back to the regular plated copper nozzle and don’t have anymore problems. The maximum flow rate went down from 40mm²/s to 25mm²/s but I can print a benchy in half an hour, so it’s still plenty fast
Yeah, this is plain PLA though and it prints fine on other printers. Maybe 200°C is too high of a temp
I haven’t used Z-hop yet, due to some bad experiences with older printers, but I might have to give that a try
Already ran through all the flow rate, pressure advance, retraction towers and maximum flow rate calibrations in Orca Slicer
Yeah, I should probably try it with a lower temperature, also got some PLA Meta filament in the post that might help