EDIT: I’ve followed [email protected] 's suggestions and I have rerouted the bowden tube. Tomorrow I’ll start another print and see the results. I’ll report back.
Here’s the whole printer during that print…
https://files.catbox.moe/smtxlj.webm
…and here’s a detail image:
The printer is a Creality CR5 Pro HT running Klipper - although I doubt this is too relevant. The extruder is of the “push type” with the hotend only including the heated nozzle. Current speed is 70mm/s in the layers but at the moment of the video 35mm/s due to the top layer.
I have no idea why, with a relatively symmetrical print just this corner is so messed up and underextruded. Any idea would be nice.
Bed leveling could be the problem, under extruding due to a low spot on that corner.
Bedmesh was created right before the print and applies, I’d rate that second after underextrusion due to the bowden tube getting bent hard. We’ll see though!