Stamets@lemmy.world to Funny@sh.itjust.works · 1 day agoWhat a moronlemmy.worldimagemessage-square50fedilinkarrow-up11arrow-down10
arrow-up11arrow-down1imageWhat a moronlemmy.worldStamets@lemmy.world to Funny@sh.itjust.works · 1 day agomessage-square50fedilink
minus-squaredfyx@lemmy.helios42.delinkfedilinkarrow-up0·1 day agoJust saying, this is not the fault of a single engineer but of a whole company that didn’t think “try all common cable types” should be a required testing step before a network switch goes into mass production.
minus-squarestraightjorkin@lemmy.worldlinkfedilinkarrow-up0·23 hours agoCisco is where good engineering goes to die.
minus-squareslazer2au@lemmy.worldlinkfedilinkEnglisharrow-up0·1 day agoYou don’t have to test every cable boot. Just have a design guide that says “Don’t put buttons above or below ports.”
minus-squareNaibofTabr@infosec.publinkfedilinkEnglisharrow-up0·1 day agoThat can be difficult to accomplish…
minus-squareslazer2au@lemmy.worldlinkfedilinkEnglisharrow-up0·1 day agoLooks like they learnt and made a recess for the buttons.
minus-squarefuckwit_mcbumcrumble@lemmy.dbzer0.comlinkfedilinkEnglisharrow-up0·1 day agoAnd it’s not in the center of the port. It’s in between two ports where a boot should never be in the way.
Just saying, this is not the fault of a single engineer but of a whole company that didn’t think “try all common cable types” should be a required testing step before a network switch goes into mass production.
Cisco is where good engineering goes to die.
You don’t have to test every cable boot. Just have a design guide that says “Don’t put buttons above or below ports.”
That can be difficult to accomplish…
Looks like they learnt and made a recess for the buttons.
And it’s not in the center of the port. It’s in between two ports where a boot should never be in the way.
That as well