Thanks for the response, that confirms my assumption, seems like I was configuring it right, but the behavior is not as expected.

• If HA is active/onscreen already, the command will do nothing.
• If HA is idle/offscreen, the command will bring HA to the forefront, but not change pages. (This is the state it is in after the “turn_off” sends the launcher intent.)
• If HA is off, the command will launch HA, and navgate to the correct page.

Is this all that is to be expected? or should I be able to get to the desired dashboard, from any previous screen or application state?

Winner winner chicken dinner! This is EXACTLY what happened. I reprinted again after tightening belts, fixing bed wobble, and re-leveling, and kept a closer eye on it this time. The nozzle was indeed catching on that “Y” support due to the edge curling up. Wasnt enough to kill the print this time, but enough to make me nervous…

Ironically, the thing I’m printing is an all-in-one case so that I can segregate the PSU, main board, pi, and controls from the printer itself to enclose it and have better temp control!