• 0 Posts
  • 6 Comments
Joined 1 year ago
cake
Cake day: July 2nd, 2023

help-circle


  • I use multiple materials from multiple brands, so yes, I do some calibration for each filaments.

    I usually limit myself to the flow factor by printing a cube in vase mode and then adjust by ±2% after a print if I feel like it is needed.

    For the temperatures, I go for the normal recommended values (200°C hot end and 60°C bed for PLA) without any calibration, unless there is a problem. (I think last time I printed one was for ABS because it kept curling up…)

    Retraction and Linear advance seems to always give roughly the same value for each type of materials, so I ended up using an average which work well enough.